Recently a small piece of the door seal on our washer dryer came out in the wash. It was small but enough to mean water on the kitchen floor so it needed replacing.
The solution seemed simple. Order a replacement seal. Fitting it however was a problem.
Indesit decided to make this model un-servicable. It’s not possible to get enough access to the drum to fit the seal without, well removing the drum. So what should be a 30 minute job took 4 hours. The case is welded together, and apparently the drum was lowered in in the factory.
So when this machine finally does pack it in an need replacing. I’ll be replacing it one that I can do basic maintenance on. Probably not an indesit if our current machine is typical of them.
this is no fun i know…thanks for sharing.